Comments on: Garmin 12-Volt Adapter Cable for GPSMap 276C

By: Robert J. Gregor

Robert J. Gregor — Fri, 23 Oct 2009 01:55:31 +0000

I purchased this power cord for a Garmin 276 gps. I specifically wanted the one clearly pictured on the website that has the 90 deg bend at the end. I bought 2. I received the item and it does not fit the 276. The contacts are correctly placed but the rubber type product that is meant for a press fit into the gps is too small in diameter and the cord immediately falls out. The end of this cord is straight and not the 90 deg. It is packaged as a Garmin product with the 276c clearly on the package so I do not know where the problem lies. I tried to contact Antonline but they do not provide for any human to contact to explain/rectify the problem so I ended up sending the cords back and eating the shipping each way. Will never buy from Antonline again.Garmin 12-Volt Adapter Cable for GPSMap 276C (010-10516-00) I would personally verify with any vendor offering this product.

By: Marceloc

Marceloc — Fri, 23 Oct 2009 00:10:27 +0000

It works as it should but it’s different from the picture. It doesn’t carry the L shaped connector on the GPS side. It’s more like an “I” connector!

By: Lawrence W. Golden

Lawrence W. Golden — Thu, 22 Oct 2009 21:17:50 +0000

I have had my original and a replacement cable with speaker break. The wiring going into the plug to the back of the Garmin unit cracks and the cable ceases to work. This adaptor cable only (without speaker) is an inexpensive solution to my problem, since my primary use of the unit is in my boat, where the speaker is useless.

By: Jose A. Contreras

Jose A. Contreras — Thu, 22 Oct 2009 19:39:39 +0000

THE CABLE IT’S NO SAME TO THE PHOTO, DO NOT HAVE A TERMINAL CIGARETTE CONNECTOR, I LOST MY MONEY. I think you wrong the part, I receive Part No. RB, have a wiring diagram for make a Gilsson RB cable for install a DB-9 serial connector, but no, I buy to you other cable whit 12 volt adapter cable.