VideoSecu Large Heavy Duty Swing WALL MOUNT for Vizio 36″ 37″ 38″ 40″ 42″ 46″ 47″ 48″ 50″ 52″ Plasma/LCD TV MPA65B 1N9
Nov 03, 2009 in
Electronics
- Fits most TVs or Monitors from 37 up to 55 inch ( check VESA and weight )
- Mounting Rails adjust from 8″ to 31″ width and max height of 18.9″, VESA compatible from 200×100 up to 700×400
- Heavy duty formed entirely of heavy gauge steel
- Tilt +15°/-15°, Mounts to 18.9″ wood studs
- Hardware pack includes standard size of screws to the TV and to the wall.
This mount is VideoSecu brand. Please report to Amazon.com if you recieve a mount without VideoSecu logo. These new dual arm cantilever mounts are a breakthrough in flat panel mount design, combining strength, easy installation, and striking product design that is unparalleled in the industry. The dual two-link arm design provides easy one-touch tilt and up to 180 degrees of swivel for virtually limitless viewing positions. Fits most flat panel LCD TVs up to 55″. Recommended use for flat panel TV weights less than 132 lbs…. More >>
Like this post? Subscribe to RSS feed!
2 comments
Wood on November 3, 2009 at 10:03 pm
The mount arrived pretty quickly and in good condition. The instructions to install the mount were for crap! but… you could easily figure out how it went up, if you just took a second to review all the parts. All screws and adapters were included, so nothing else needed to install. Once up on the wall however,was a little protruding. It really sticks off the wall about 6 inches or more. Not very flush. We have a 52″ Plasma that went up on this bracket. It holds it well, but seems to sag a bit. With a TV that large and heavy, we tend not to use the full articulation of this mount because it is just to dang heavy to move and then get it back to where you wanted it. It is just okay… if i could return it for the regular wall mount… i would!
Andrew Scott on November 4, 2009 at 12:41 am
A nice product works real well and is strong. The only problem I had were the instructions that were pretty bad but once you figure out the screws etc you need it was easy. Bear in mind you will not be using hardly any of the screws nuts etc.